Next there are 3 bolts accessed in the lower front edge between the panel and inner body. Jack up and support the corner of the car, and remove the wheel. Did you build panels, or buy them pre-cut? Vince- The rear fenders are spot welded in. Hover the mouse to see where a link goes. Looking at parts catalogues would suggest that the fender is removable.
fender removal question : MG Midget Forum : MG Experience Forums : The MG Experience
Moss helps hundreds of us each year by supplying not only complete fenders, rocker panels, and floor boards, but also repair panels which are designed to replace those areas of your car which are prone to rusting. Floors and sills always before removing the body from the frame if the car has a separate frame are followed by inner fender and door pillars, after which come rocker panels and then fender patches. Start from the inside out. Note that the repair insert has not yet been welded to the inner fender.
And, although it very tempting to just use an after-market patch, to replace the rusty outer sheet metal of the A-post, you will get much better results by replacing the outer shell of the A-post from top to bottom. Some crop spraying chemicals are also active rusting agents, while salt spray in coastal areas often turns cars into dangerous hulks of rusty steel lace. In this case, the aluminum and steel, in the presence of moisture, act as an electric battery, especially when the moisture is salt-laden and the temperature is warm. To add your reply, or post your own questions Members Sign In.
The chrome bumpers are almost useless. The pictures below show the two different styles of grills that will work with the Rubber Bumper car at the bottom. Again the screw was mentioned in the manual I used but not the bolt. Also in the photos, you can see that I've rebuilt the trunk floor extension. The beading was a way of reducing cost in dealing with the seam, its a T insert that is welded between the inner and outer portions of the bodywork. You'll obviously need to remove the carpet or trim panel to access these three bolts. May 18, 1: